Tag Archives: mouse ears

Make your own Minnie (or any) Mouse ears!

For Christmas, we decided to give The Munchkin a Disney World vacation. We just got back from a long weekend of riding Teacups (3 times!), walking a LOT, & meeting pretty much every character there is. We all had a blast!

While contemplating how to present her with her Christmas gift, I decided to give her some Minnie ears, knowing that she’d probably ask for some once she saw everyone else wearing them anyway. Making them was a much cheaper option than buying them, & after her Angelina Ballerina Halloween costume, I had already mastered the proper “ear technique.” I simplified the method I found here for both sets of ears.

  • a headband in your desired color
  • a sheet of scratch paper & a pen
  • a sheet of stiffened felt (preferably the adhesive kind) in your desired color
  • sharp scissors
  • a glue gun
  • optional: wide wired ribbon for the bow
  • optional: another piece of stiffened felt in a contrasting color if you’re making “real” mouse ears like I did for Angelina
  1. Begin by finding a round object like a glass in the right size for your ears. Trace the glass onto your paper. Then draw a little rectangle below that about half the width of your headband. There may be some trial & error finding just the right size to fit around the headband. Fold the paper at the bottom of the rectangle & cut out the shape so there’s a mirror image at the bottom that resembles a dumbbell.
  2. Trace that shape onto the back (adhesive side) of your felt, then cut it out.
  3. Mark on your headband where you want your ears to go. Remove the adhesive from your felt, then put a line of hot glue on the underside of the headband in the appropriate spot for one ear & stick the felt there. Make lines of glue on the felt on either side of the headband & then do a glue circle a quarter to half an inch from the edge of one of the circles. Very carefully stick the whole thing together from bottom to top. The adhesive gives you less wiggle room (one stick is all you get — no repositioning), but it also creates a much better seal with no glue oozing out.
  4. Repeat on the other side. (Preferably while watching Top Gear, apparently.)
  5. Now for the bow. Cut a length of ribbon & loop it with ends together, then pinch in the middle. (Sorry it’s so blurry.) If you want a “poofier” bow, loop it twice & then spread the loops into kind of an X. Glue some of the overlapping bits in the middle together, if desired.
  6. Now cut several more inches of the ribbon. On the back (non-printed) side of the ribbon, place a dot of glue on the top middle & fold a third of it over lengthwise. Place another dot of glue on top of that & fold the remaining third. Now you have a skinny middle piece. Place another dot of glue on the back of one end of said skinny piece, secure it to the bottom side of your bow, & start wrapping it around the middle of the bow, securing with glue as you go. There will be some ribbon left.
  7. Finally, put a larger dot of glue on the top of your headband. Stick your bow to it, then wrap the skinny bit of ribbon around both it and the headband, once again securing with glue as you go.
  8. You’re done! (This is the picture of her after she opened her present on Christmas morning.)


I'm Lovin' It at TidyMom

Get Your Craft On Tuesdays



Filed under Crafts